Interface Switching

From Scriptel Wiki
Jump to navigation Jump to search

Before you can switch the interface of a ScripTouch signature pad, you must be sure the following items are true.

  • The signature pad is already EasyScript 3.0 compatible.
  • The signature pad is already plugged in.
  • All necessary software is already installed.

Instructions for ScripTouch Toolbox

Note: These setting will persist even if the pad is turned off.

  1. Open the ScripTouch Toolbox.
    Switching Interface w Toolbox 01.png
  2. Navigate to the output tab.
    Switching Interface w Toolbox 02.png
  3. Locate the Output mode Radio buttons, click the button for the desired interface.
    Switching Interface w Toolbox 03.png

Instructions for ScripTouch Assist

Note: These settings will NOT persist through a power cycle.

Method 1: Change the setting through the Assist menu

  1. To open the ScripTouch Assist menu, click on its icon in the notification area of your computer’s taskbar. The options for Assist will be displayed.
    Switching Interface w Assist 01.png
  2. The third line shows the opposite name of the protocol you are currently using, allowing you to switch by just clicking on it. In the example, the interface has been changed to EasyScript.
    Switching Interface w Assist 02.png

Method 2: Set a hotkey

  1. To open the ScripTouch Assist menu, click on its icon in the notification area of your computer’s taskbar. The options for Assist will be displayed.
    Switching Interface w Assist 01.png
  2. Click the hotkey option.
    Switching Interface w Assist 03.png
  3. Create new hotkey combination.
    File:Switching Interface w Toolbox 04.png
  4. Click the Save button.
  5. Use the new hotkey button to switch between interface modes.